EPOXY PRIMER COAT – RANA 801 P
EN.TDS
RANA 801 P
Product information
1-Poly amide epoxy primer.
2-Suitable for variety of substrates.
3-Excellent rust inhibitive shop primer in corrosive environments.
4-Excellent resistant with a suitable topcoat to water, chemicals
and petroleum products.
Physical data
Color: customer request
Finish: Flat
Flash point:
Resin: 34°c
Cure: 36°c
Solvent: 28°c
Volume solids: 58±2%
D.F.T: 60-70 microns
Specific gravity(mixed): 1. 67± 0.05gr/cm3
Theoretical coverage: 9.6 m2 /lit (at 60 µ D.F.T)
Drying time at 25°c:
Touch dry: 3 hrs
Dry to handle: 6-8 hrs
Full cure: 7 days
Component: 2
Pot life: 6-8 hrs at 25 °c:
Mixing ratio(by volume):
Resin: refer to can label
Cure: refer to can label
Application methods: conventional spray or brush or
Airless spray or roller
Recoat intervals* : 10°c 25°c 40°c
(mild condition) : Min: 25 hrs 12 hrs 5 hrs
**Max: NONE NONE NONE
**Maximum Recoat: Unlimited. Must have a clean, dry surface for top coating.”Loose” chalk or salts must be removed in . accordance with good painting practice. Drying time is temperature, humidity, and fi lm thickness dependent
Recommended thinner: RANA THINN 80
Recommended cleaner: RANA CLEAN 80
Shelf life: 12 months when stored indoors in unopened
Original containers at 5 to 40°c (cool and dry
Place).
Curing mechanism: by solvent release and reaction by
Curing agent and resin
RANA 801 P
Typical uses
1-As a maintenance and repair primer coat in moderate
to severely corrosive environment.
2-As a high performance coating for marine and industrial
facilities, ballast and potable water tanks, bilges,
and draining pipes, above and bellow water hulls.
Application equipment
The following equipment is listed as a guide and suitable
equipment from other manufactures may be used.
adjustments of pressure and change of tip size may be
needed to obtain the proper spray characteristics.
1-Airless spray:
2-Conventional spray:
3 -Mixer:mixer must be powered by an air motor or an explosion
proof electric motor.
4-Brush or roller.
Application procedures
1-Flush equipment with cleaner before use.
2-Stir resin to an even consistency with a power mixer.
3-Add cure to resin and continue stirring for 5 minutes.
Note:since the pot life is limited and shortened by high
temperatures ,do not mix more material than will be used
in 8 hours at 25 °c.
4- Thinning with RANA THINN 80 for necessary
5-Stir during application to maintain uniformity of material
and apply a wet coat in even parallel passes after 20 minutes.
6-Clean all equipment with cleaner immediately after use.
RANA 801 P
Environmental condition
Environmental temperature must be 10-40°c.
Surface temperature must be at least 3°c above dew point
to prevent condensation. At freezing temperature surface
must be free of ice and relative humidity below 80 %.
Surface preparation
Sand blasting to standard Sa 2.5 – Sa3 , SIS 05 5900 , ISO 8501-1.
Sorry, the comment form is closed at this time.