can coating – RANA 663 T
EN.TDS
Product information
1-Designed for interior of oils grease, chemical materials
acid, alkali and solvent’s drum.
2-Excellent resistance to water, saline water and solvents.
3-Excellent resistance to alkali, acid and oils.
4-Hard, tough, flexible and abrasion resistant.
5- Designed for application directly over steel.
6- Excellent rust inhibitive in corrosive environments.
Physical data
Colour: customer request
Finish: Flat
Flash point: 28°c
Volume solids: 53±2%
D.f.t: 15 -20 microns
Specific gravity: 1.15± 0.05gr/cm3
Theoretical coverage: 35.3 m2 /lit (at 15 µ d.f.t)
Baking condition:
Flushing time: 10 minutes
Stoving time: 10-15minutes
Stoving temp. 200°c-220°c
Component: 1
Application methods: conventional spray or brush or
Roller
Recommended thinner: RANA THINN 66
Recommended cleaner : RANA CLEAN 66
Shelf life: 6 months when stored indoors in unopened
Original containers at 5 to 40°c (cool and dry
Place).
Curing mechanism: heat curing
Substrate: steel
|
|
Typical uses
As a coating for interior of drums containing oils ,
acid, alkali, solvents and chemical materials .
Application information
This RANA CHEM’s product is coating
which has excellent resistance to chemical material,
alkali , acid , oil and water .
To obtain the maximum performance for which this product
is formulated,strict adherence to all application,instructions,
precautions,conditions and limitations is necessary.
Application equipment
The following equipment is listed as a guide and suitable
equipment from other manufactures may be used.
Adjustments of pressure and change of tip size may be
needed to obtain the proper spray characteristics.
1-Conventional spray:industrial equipment with suitable
aircap having a fluid tip with A 1.4-1.6mm orifice .
2-Mixer: mixer must be powered by an air motor or an explosion
proof electric motor.
Caution
1-Handle with care.
2-Avoid inhalation of possible solvent vapours or
paint mist,as well as paint contact with skin and eyes.
3-Apply only in well ventilated areas and ensure that
Adequate forced ventilation exists when paint applies is
In confined spaces or when the air is stagnant.
4-Always take precautions against the risks of fire
and explosions.
5-Harmful or fatal if swallowed,immediately seek medical
|
|
assistance if swallowed.
6-Use fresh air masks and explosion proof equipment.
Application procedure
1-Flush equipment with recommended cleaner before use.
2-Stir paint for 5 minutes.
3- For spray,thin only as needed for workability.
4-Apply a wet coat in even, parallel passes.overlap
each pass 50% to avoid bare areas,pinholes or holidays.
5-Small damaged or bare areas and random pinholes or
holidays can be touched up by brush.
6-Clean all equipment with recommended cleaner
immediately after use.
Environmental condition
Environmental temperature must be 10-40°c.
Surface temperature must be at least 3°c above dew point
to prevent condensation. At freezing temperature surface
must be free of ice and relative humidity below 80 %.
Surface preparation
The surface must be clean and dry .all dirt, grease and other
foreign materials ` should be removed .
Sorry, the comment form is closed at this time.